Hardwired Beltpack Monitor with Input Cable for PSM 600 In Ear Monitoring System without earphones
|
|
By: Shure
Microphones, Headphones & Wireless systems
|
The Shure P6HW Personal In Ear Monitor is the hardwired two-channel stereo solution for the stage performer in the PSM 600 series of monitoring products. The P6HW personal beltpack monitor effectively replaces the bulk and clutter of the traditional stage monitor/wedge setup. In Ear monitoring offers the performer more mobility and a roomier stage and the house engineer a lower volume, feedback free stage environment.
P6HW features include:
- Four Dip Switches offer a high frequency boost, on/off and defeat control of the built in limiter,a 15 dB pad, and MixMode or stereo mix selection; located in battery compartment
- This integrated on/off and volume knob offers easily accessible level control
- Three dedicated LED's include power,low battery and peak/overloading
- This offers dedicated control of left/right balances in stereo mode or the mix level of two different mono signals in MixMode
- Rugged, yet lightweight and inconspicuous
Frequency Response |
26 Hz to 20 kHz (-3 dB) |
Signal-to-Noise Ratio |
85 dB |
Channel Separation |
40 dB |
Maximum Input Level |
+22 dBu, Input Pad On, +7 dBu, Input Pad Off |
Input Pad Switch |
15 dB DIP switch located in battery compartment |
Output Level |
+4.5 dBu (Maximum Level), Left and Right |
Input Connections |
5 pin LEMO |
Input Cable |
5 pin LEMO male to dual XLR female Y type |
Power Requirements |
9 volt battery |
Battery Life |
10-12 hours; varies with type, quality and output of earphones used |
Limiting |
Built in, fixed threshold |
Equalization |
Flat or 6db at 5 kHz boost |
Personal Mix Control |
MixMode and balance control knob |
Dimensions |
4.371 x 2.54 x 1.256" (111 x 64.5 x 31.9mm) |
Weight |
7.4 oz. (209.8 g) |
© 1996 - 2024 | All Rights Reserved
Audio Video Supply Inc.
4542 Ruffner St. Suite 220
San Diego, CA 92111
Prices and specifications subject to change without notice.